MECHAMMER MARK-II

The Octo shape prevents the tool from rotating during use, also a twist of 45 degrees is possible. Hammer head made of high quality hardened tool steel CNC manufactured. Wide range of upper and lower dies available. The slogan for this machine is “SET IT and FORGET IT”. This means that once it has been adjusted to your working height there are no further adjustments left. Changing the dies is child's play.The pressure on the panel is constant and is not affected by the material thickness. Mechanical control by means of foot pedal. This operation can be done with both feet on the ground. Pressing the pedal increases the speed and with it the impact force. The use of a compressor is therefore superfluous with this machine, so no (leaking) hoses on the floor, no changing filters, no draining of water, etc.
In short, time for the new generation Planishing and Shaping Hammer!

 

Specifications:

• Type: Mark II

• Seal of approval: CE

• Engine power: 400 W

• Voltage: 230 Volt

• Switch: On - Off - Emergency stop

• Number of strokes per minute: variable 150 - 3000 min -1

• Max. material thickness to be machined: soft steel up to 2 mm, aluminium up to 3 mm (with the right tool choice)

• Weight: 79 kg

• Dimensions: lxwxh: 90 x 50 x 200 cm

• Finishing: powder coating

• Anchoring: adjusting feet that are fixed to the floor

• Discharge: 500 mm

• Lubrication: oil for air tools

• Implementation: 1 fixed and 1 adjustable arm with in both an Octo shaped tool holder

• Tooling: the Mechammer is delivered with 1 flat lower part and 1 flat upper part of 40 mm round

 

Included:

- 1 flat lower part (40 mm round)

- 1 flat top stamp (40 mm round)