MILLERS OIL CLASSIC RUNNING-IN OIL - 1 LITER is available to buy in increments of 1
Description
Use this inlet oil for the first run of rebuilt engines. The formula is made for running-in on public roads. Can be used for testing. Run the engine with the highest torque (pulling power) to ensure maximum running-in of the piston rings.
Then drain the engine and fill it with the Millers Oil that is most suitable for the engine. The running-in oil is suitable for limited road use (500 to a maximum of 1000 kilometres). We advise you there to replace the walk-in oil.
ADVANTAGES:
High quality mineral oil formulated to solve the problems experienced with reconditioned engines that do not embed.
Provides full protection for high load valves and associated components, while allowing the piston rings to be bedded against the bore.
Good running-in ensures optimum performance and fuel efficiency of a reconditioned engine.
Reduces leakage (4%) after thorough running-in.
PERFORMANCE PROFILE:
API: SE, CC
Features:
SAE Viscosity: 30
Density (at 15 °C): 0,887
Kinematic Viscosity (at 100 °C, cSt): 11.9
Kinematic Viscosity (at 40 °C, cSt): 104
Viscosity index: 103
Point of flow (°C): -15
Flash point (°C): >200
TBN (mg KOH/gm): 4.4
Please note that metal cans are prone to dents during transport. Even though these products are packed carefully by our team, there is no guarantee for the cans not to be dented in transport once they have been dispatched by us.
We found other products you might like!
